Adafruit nRF8001 library for Arduino
adafruit/Adafruit_nRF8001 is driver and example code for Adafruit's nRF8001 Bluetooth Low Energy Breakout.
PINOUT
The pin locations are defined in ble_system.h, the supported systems are defined in hal_aci_tl.cpp. The following pinout is used by default for the Arduino Uno:
SCK -> Pin 13
MISO -> Pin 12
MOSI -> Pin 11
REQ -> Pin 10
RDY -> Pin 2 (HW interrupt)
ACT -> Not connected
RST -> Pin 9
3V0 - > Not connected
GND -> GND
VIN -> 5V
RDY must be on pin 2 since this pin requires a HW interrupt.
3V0 is an optional pin that exposes the output of the on-board 3.3V regulator. You can use this to supply 3.3V to other peripherals, but normally it will be left unconnected.
ACT is not currently used in any of the existing examples, and can be left unconnected if necessary.
Related:
- Test nRF8001 Bluetooth LE module with nRF Master Control Panel (BLE) App on Android phone
No comments:
Post a Comment